Hyundai Genesis: Rear Seat / Rear Seat Cushion Cover Repair procedures
• |
Put on gloves to protect your hands. |
|
• |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage. |
• |
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. |
• |
Take care not to bend or scratch the trim and panels. |
|
1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
2. |
After removing the hog-ring clips inside the rear seat cushion cover, remove the rear seat cushion cover (A).
[Rear side] 
[Front side] 
|
3. |
Install in the reverse order of removal.
• |
After removing the hog-ring clips (A) inside the rear seat cushion cover, remove the rear seat cushion cover (B). |
• |
Replace the hog-ring clips with new ones using special tool (C) (09880-4F000). |
|

|
Component Location
1. Rear seat cushion cover [LH]2. Rear seat cushion cover [RH]
...
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with pr ...
Other information:
If you place the Engine Start/Stop
button in to the ACC or OFF position
with the headlamps ON, the headlamps
(and/or parking lamps) remain
on for about 5 minutes. However,
with the engine off if the driver’s door
is opened and closed, the headlamps
(and/or parking lamps) are
turned ...
Specification
ItemSpecificationTypeDILKR7A11Gap 1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.)
...