Hyundai Genesis (DH): Cylinder Block / Rear Oil Seal Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures

Removal
1.
Remove the drive plate and adapter plate.
(Refer to Cylinder Block - "Drive Plate")
2.
Remove the rear oil seal (A).

Installation
1.
Using SST(09231-3C200, 09231-H1100), install the rear oil seal.

   
Always use a new oil seal.
2.
Install the drive plate and adapter plate.
(Refer to Cylinder Block - "Drive Plate")

    Components 1. Rear oil seal2. Rear oil seal case

    Components 1. Piston ring2. Piston pin3. Snap ring4. Piston5. Connecting rod6. Connecting rod upper bearing7. Connecting rod lower bearing8. Connecting rod bearing cap

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

    C

    Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

    Component Location Index Engine Room [Lambda Engine] 1. Expansion Valve2. Suction & Liquid Tube Assembly3. Service Port (Low Pressure)4. Service Port (High Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Condenser8. Receiver-drier [Tau Engine] 1.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0329