Hyundai Genesis (DH): Cylinder Block / Rear Oil Seal Components and Components Location

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Components and Components Location

Components

1. Rear oil seal
2. Rear oil seal case

    Removal and Installation 1. Disconnect the battery "-" terminal from the trunk room. 2. Remove the automatic transaxle . (Refer to Automatic Transaxle System - "Automatic Transaxle") 3.

    Removal 1. Remove the drive plate and adapter plate. (Refer to Cylinder Block - "Drive Plate") 2. Remove the rear oil seal (A). Installation 1.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Repair procedures

    R

    Hyundai Genesis (DH) 2013-2016 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0382