Hyundai Genesis: Seat Electrical / Climate Seat Unit Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Seat Electrical / Climate Seat Unit Description and Operation

Description

Comparing with the seat heat function by the existing thermic rays, Climate Control Seat functions the heating, cooling, dehumidifying by using TED.

It inhales the indoor air through the blower installed at the seat cushion lower part, and supplies the air into the seat cushion and the seat back through the duct.

It heats or cools the air supplied from TED set up at the tip of the duct.

It sends a slightly heated or cooled air throughout the seat surface through the air channel set up at seat cushion and seat back.

1) TED is a chip used for the system exchanging heat with electricity.

2) It is the next generation cooling system which can substitute for the compressor cooling system.

It can simply generate heating and cooling at once through the electric poles conversion, and also keep a steady temperature through cooling and heating an object between -30°C and +150°C.

Climate Seat Unit Schematic Diagrams

Circuit Diagram ...

Climate Seat Unit Repair procedures

Removal [Front seat - ventilation blower Seat] 1. Disconnect the battery(-) terminals. 2. Remove the front seat. (Refer to Body - "Front Seat Assembly" ) 3. Remove the front seat under ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: CVVT Oil Temperature Sensor (OTS) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OTS connector. 3. Remove the OTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2. 5. Check that the resistance is within t ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Windshield Deicer Repair procedures

Inspection 1. Remove the cowl top cover. (Refer to Body - "Cowl Top Cover") 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition switch ON and the windshield deicer switch ...