Hyundai Genesis (DH): Cylinder Block / Drive Plate Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate Repair procedures

Removal and Installation
1.
Disconnect the battery "-" terminal from the trunk room.
2.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
3.
Remove the adapter plate (B) and the drive plate (A).
Tightening torque :
71.6 ~ 75.5 N.m (7.3 ~ 7.7 kgf.m, 52.8 ~ 55.7 lb-ft)

4.
To install, reverse the removal procedure.

    Components 1. Drive plate2. Adapter plate3. Crankshaft adapter

    Components 1. Rear oil seal2. Rear oil seal case

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Repair procedures

    Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0232