Hyundai Genesis: Rear Door / Rear Door Belt Outside Weatherstrip Repair procedures
| 1. |
Pull down the rear door window glass to the lowest level by pressing the power window glass switch. |
| 2. |
After loosening the mounting screws, remove the rear door belt outside weartherstrip (A) by pulling it upward. 
|
| 3. |
Install in the reverse order of removal.
| • |
Replace any damaged clips. |
|
|
Replacement
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the rear door outside handle cover (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ...
Replacement
1.
Loosen the rear door checker (B) mounting bolt.
2.
Detach the clips, then remove the rear door side weatherstrip (A).
Tightening torque :
16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, ...
Other information:
Specifications
ItemSpecificationsTransmission typeA8LR1Engine modelGasoline 3.8GDI (SBC)Torque converter type3-element, 1-stage, 2-phase typeOil pump systemInternal gear typeFriction elementsClutch: 4EABrake: 2EAOWC : 1EAPlanetary gear 3EAGear ratio1st3.6652nd2.3963rd1.6104th1.1905th1.0006 ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the photo & auto light sensor.
(Refer to Windshield Wiper/Washer - "Rain Sensor")
Installation
1.
Install the auto light sensor.
2.
Connect the negative (-) battery terminal. ...