Hyundai Genesis: Floor Console / Rear Console Cover Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. • Take care not to bend or scratch the trim and panels.

1.	Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly")

2.	Remove the floor console armrest. (Refer to Floor Console - "Front Console Armrest")

3.	Loosen the mounting screws (A) located on the upper and rear sides of rear console cover.

4.	Disconnect the connector (A).

5.	Install in the reverse order of removal. • Make sure the connector is connected properly. • Replace any damage clips.

Rear Console Cover Components and Components Location

Component Location 1. Rear console cover ...

Crash Pad

...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Power Trunk Module Drive Unit Description and Operation

Description 1. Power trunk drive unit(Trunk open) A. The trunk open switch operates. (Trunk outside handle switch, Crash pad switch, SMK trunk open button) B. The power trunk motor operates and motor gear rotates. C. The sector gear rotates. D. The drive arm connected to sector gea ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Hood Latch Components and Components Location

Component Location 1. Hood latch assembly ...