Hyundai Genesis: Front Bumper / Radiator Grill Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. • Take care not to bend or scratch the trim and panels.

1.	Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover")

2.	Remove the fixing clip (A) and then the front bumper energy absorber (B).

3.	Remove the pantoscopic camera. (Refer to Body Electrical System - "Pantoscopic Camera")

4.	Loosen the radiator grill mounting screws.

5.	Using a screwdriver or remover, pull the clip (A) upward and remove the radiator grill (B).

6.	Install in the reverse order of removal. • Make sure the connector is connected properly. • Remove any damaged clips.

Radiator Grill Components and Components Location

Component Location 1. Radiator grill ...

Rear Bumper

...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Propeller Shaft Repair procedures

Inspection Inspect Flexible Coupling 1. Check the front and rear flexible couplings for cracks or damage. 2. Inspect the flexible coupling centering bushing.If the busing is damaged, replace the propeller shaft assembly. Propeller Shaft Runout 1. Install a dial indicator with its needl ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Steering Wheel Remote Controller (SWRC) Schematic Diagrams

Circuit Diagram ...