Hyundai Genesis: Power windows / Power window lock switch

The driver can disable the power window switches on the rear passengers' doors by pressing the power window lock switch. The indicator will be illuminated.

When the power window lock switch is pressed:

  • The driver's master control can operate all the power windows.
  • The front passenger's control can operate the front passenger's power window.
  • The rear passenger's control cannot operate the rear passengers' power window.

WARNING

Do not allow children to play with the power windows. Keep the driver’s door power window lock switch in the LOCK position. Serious injury or death can result from unintentional window operation by a child.

CAUTION

  • To prevent possible damage to the power window system, do not open or close two windows or more at the same time. This will also ensure the longevity of the fuse.
  • Never try to operate the main switch on the driver's door and the individual door window switch in opposite directions at the same time. If this is done, the window will stop and cannot be opened or closed.
Power windows
The Engine Start/Stop button must be in the ON position to be able to raise or lower the windows. Each door has a Power Window switch to control that door's window. The driver has a Power Wi ...

Panorama sunroof
The Engine Start/Stop button must be in the ON position before you can open or close the sunroof. ✽ NOTICE In cold and wet climates, the sunroof may not work properly due to freezing con ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Special Service Tools


Special Service Tools ItemIllustrationApplicationFuel Pressure Gauge(09353-24100)Measuring the fuel line pressureFuel Pressure Gauge Adapter(09353-02100)Connection between the high pressure fuel pump and the fuel feed lineHeated Oxygen Sensor Socket Wrench(09392-1Y100)Removal and installation o ...

Hyundai Genesis (DH) 2013-2016 Service Manual: 27 Brake Control Solenoid Valve Repair procedures


Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between solenoid valve terminals. 4. Check that the resistance is within the specification. ...

© 2013-2024 www.hgenesisdh.com