Hyundai Genesis (DH): Power Trunk Module / Power Trunk Module Drive Unit Components and Components Location
Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Power Trunk Module / Power Trunk Module Drive Unit Components and Components Location
| Component Location |
| 1. PTM motor gear 2. Sector gear 3. Drive arm | 4. Push rod 5. Push rod pin |
The initialization and learning value saving All initialization and setting of PTM cannot be done by the diagnosis tool (GDS).
Circuit Diagram Block Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.
Hyundai Genesis (DH) 2013-2016 Service Manual: Evaporator Temperature Sensor Repair procedures
I
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- 4 Wheel Drive (AWD) System
- Electric Parking Brake (EPB) Repair procedures
- ECS-G Sensor Repair procedures
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0221