Other information:
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Put a flat tool(O4mm) into a guide hole located in the bottom of steering wheel and press a spring.
When put a tool into a hole, make sure not to damage an ...
Inspection
1.
Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch.
No.Description1BAT (+)2Illumination (+)3-4Signal5Pilot lamp6-7Illumination (-)8GND
Removal
•
Wrap the protective tape on the tool to di ...