Hyundai Genesis (DH): Hydraulic System / Oil Filter Repair procedures
| Replacement |
| 1. |
Completely drain ATF. |
| 2. |
Remove the valve body cover (A).
|
| 3. |
Oil filter is integral with the valve body cover, so replace the valve body cover.
|
| 4. |
Fill the oil of about 7.0 liters through oil injection hole. |
| 5. |
Check the oil level.
(Refer to Hydraulic system - "Fluid") |
Service Adjustment Procedure Oil level Check The ATF level check is not normally required during scheduled services. If an oil leak is found, perform the oil level check procedure after repairs are completed.
Description The valve body is essential to automatic transmission control and consists of various valves used to control the oil feed from the oil pump.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
Description Control Function This system supports 2 kinds of main function. (Rear video display function, Expected trace of wheels display function) The Rear video display and the expected trace of wheels display operate according to Vehicle speed condition and Gear position.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- General Information
- Body (Interior and Exterior)
- Rain Sensor Repair procedures
- New on site
- Most important about car
