Hyundai Genesis: Panorama Sunroof / Movable Glass Repair procedures
1. |
By pushing the panorama sunroof switch, fully open the movable glass. |
2. |
Separate both decoration covers (A) and then remove the folding cover (B). 

|
3. |
By pushing the panorama sunroof switch, fully close the movable glass using the panorama sunroof switch. |
4. |
Adjust the height of the glass by slightly loosening the screws (A).
• |
Be careful not to damage the screw. |
|

|
5. |
Carefully lift up the movable glass (A) and then remove it. 
|
6. |
Install in the reverse order of removal.
• |
After replacing the movable glass, align the glass with the body frame as necessary. |
|
|
Adjustment
Inspect Glass Alignment
1.
Check the alignment of the movable glass (C) located between the front (A) and rear (B) glass and adjust it if necessary.
Alignment adjustment
Standard v ...
Removal
•
In order to remove the front glass, use the tools shown in the following figure:
[Tooling Diagram]
Square wire
Insert-type wire grip
[Tooling Assembly Di ...
Other information:
Warning Lamp Activation
Warning Lamp Behavior after Ignition On
As soon as the operating voltage is applied to the SRSCM
ignition input, the SRSCM activates the warning lamp for a LED lamp
check.
The lamp shall turn on for 6 seconds during the initialization phase and turn off afterward. ...
Removal
1.
Turn the engine OFF.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
4.
Pull up the lock of the SRSCM connector to disconnect the connector ...