Hyundai Genesis (DH): Automatic Transmission Control System / Line Pressure Control Solenoid Valve Specifications
Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Line Pressure Control Solenoid Valve Specifications
| Specifications |
Line Pressure Control VFS
? Control type : Normal high type
| Control Pressure kpa (kgf/cm?, psi) | 0~500.14 (0~5.1,0~72.54) |
| Current value(mA) | 0~850 |
| Internal resistance(?) | 4.8~5.4 |
Description Line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic presssure inside the line presure .
Circuit Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Unit Repair procedures
R
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- General Information
- Engine Electrical System
- Evaporative Emission Control System
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.03