| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Open the sunglass case cover from the overhead console and
remove the 2 screws holding the overhead console. Disconnect the switch
connector and Map lamp connector, and then remove the overhead console
lamp (A).
|
| 3. |
Check for continuity between the terminals. If the continuity is not shown as specified, replace the panoramaroof switch.
|
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the panorama sunroof motor (A) after loosening the screws and disconnecting the connector.
Description The ambient temperature sensor is located inside the side mirror and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature. The sensor output will be used for discharge temperature control, temperature regulation door control,
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.