Hyundai Genesis (DH): Windshield Deicer / Windshield Deicer Repair procedures

Inspection
1.
Remove the cowl top cover.
(Refer to Body - "Cowl Top Cover")
2.
Disconnect the windshield deicer connector (A) from the wiper motor linkage.

3.
Check for continuity between the terminals of deicer lines.

4.
Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between the terminals of harness side deicer connector.

OK : approx. Battery voltage (12V)

    Component Location Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay.

    Inspection 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (GDS). (1) Checking failure and code number (DTC) (2) Current data : Checking the system input/output data state (3) Actuation test : Checking the system operation condition (4) Additional function : Controlling other features including system option setting and zero point adjustment 2.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: High Mounted Stop Lamp Repair procedures

    Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the high mounted stop lamp assembly (A) after loosening the mounting screws. Installation 1.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Troubleshooting

    Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. The following is the summarized A/S procedure. NoProcedure1Park the vehicle on level ground2Tire check3IGN1 ON4Head lamp Low Beam ON5Connection with diagnostic tool6Initial command by diagnostic tool7Clear DTC Code8IGN1 OFF > ON9Re- Connection with diagnostic t

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0211