Hyundai Genesis (DH): Automatic Transmission Control System / Shift Cable Components and Components Location
| Components |
| 1. Shift lever knob 2. Shift lever boots | 3. Shift lever assembly 4. Shift cable |
Removal 1. Remove the console upper cover (A). 2. Pull the shift lever knob (B) upward to remove it. 3. Remove the knob&boots(A) from the console upper cover.
Removal 1. Remove the nut (B) and clip (C). 2. Remove the shift cable (A) assembly from the transmission. Tightening torque : 12.7 ~ 15.7 N.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Combination Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. After loosening the nuts (4EA) holding the rear combination lamp and disconnecting the connector (A), remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turning it in the counter clock-wise direction.
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Starter Repair procedures
- Front Door
- Engine Electrical System
- New on site
- Most important about car
