Hyundai Genesis (DH): Power Trunk Module / Power Latch Assembly Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Power Trunk Module / Power Latch Assembly Description and Operation

Description
1.
Power latch lock flow

A.
When the trunk being open closes, the striker get locked.
B.
The CLAW rotates (1st step close).
C.
When the 1st step close is detected, the cinching cable starts rotating.
D.
The cinching lever starts operating.
E.
The CLAW rotates for the operation of the cinching lever. (2nd step close)
F.
Trunk is completely closed.
2.
Power latch unlock flow
(1) The operation principle of PTM unlock process is equal to that of the general trunk latch.
(2) The unlock process is completed by using the motor in the power latch.

    Component

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid trim after opening the trunk. (Refer to Body - "Trunk Lid Trim") 3.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Components and Components Location

    C

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.036