Hyundai Genesis (DH): Air Conditioning System / In-car Sensor Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / In-car Sensor Description and Operation

Description
An in-car air temperature sensor is located in the crash pad lower panel.
The sensor contains a thermistor which measures the temperature of the cabin. The signal determined by the resistance value which changes in accordance with perceived inside temperature, is delivered to the heater control unit and according to this signal the control unit regulates the in-car temperature to the intended value.

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal

    Inspection 1. Turn the ignition switch ON. 2. Blow warm air into the in-car sensor air inlet. Measure the sensor resistance between 1 and 3 terminals.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Climate Control Air Filter Repair procedures

    Replacement 1. Remove both stoppers (B) by turning them from the glove box (A). 2. Disconnect the air damper (A) from the glove box (B). 3. Remove the filter cover (A) by pressing the knob. 4. Replace the air filter (A) with a new one according to the direction of air filter.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0203