Hyundai Genesis (DH): Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and with ignition ON.
Condition
Output Voltage (V)
IG ON
Approx. 4.44V
Idle
Approx. 0.75V

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor connector (A).
3.
Remove the installation bolts (B), and then vertically remove the sensor from the surge tank.

Installation
   

    Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Hyundai Genesis (DH) 2013-2016 Service Manual: CO2 Sensor Description and Operation

    Description This system maintains the density of carbon dioxide constantly in vehicle interior by measuring the amount of carbon dioxide to increase the comfortableness and the fuel consumption rate when air conditioning system is operating.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0251