Hyundai Genesis (DH): Engine Control System / Injector Repair procedures
| Inspection |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the injector connector. |
| 3. |
Measure resistance between the injector terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
Circuit Diagram Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. Other information:Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor. Hyundai Genesis (DH) 2013-2016 Service Manual: Ambient Temperature Sensor Description and OperationDescription The ambient temperature sensor is located inside the side mirror and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature. The sensor output will be used for discharge temperature control, temperature regulation door control, Categories
Copyright В© 2026 www.hgenesisdh.com - 0.03
|