Hyundai Genesis (DH): Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to

    Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

    Component Location Index Engine Room [Lambda Engine] 1. Expansion Valve2. Suction & Liquid Tube Assembly3. Service Port (Low Pressure)4. Service Port (High Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Condenser8. Receiver-drier [Tau Engine] 1.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Repair procedures

    Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0251