Hyundai Genesis (DH): Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and Operation

Description
The fuel pressure sensor (FPS) is installed on top of the low pressure fuel pump and measures the pressure of the low pressure fuel line. Based on the current fuel pressure and the amount of fuel consumed, the fuel pump control module (FPCM) determines whether to activate the low pressure fuel pump. After activating the low pressure fuel pump, the FPS continues to communicate with the FPCM to measure the fuel pressure and control the supply of low pressure fuel.

    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. If there is DTC on the GDS, replace the FPCM. 3. Check the output voltage of fuel pressure sensor (FPS).

    Specification Pressure(kPa)Output Voltage(V)500.36002.511004.5

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Seal2. Intake Duct Case3. Intake Door4. Intake Actuator5. Intake Duct Case (A)6. Climate Control Air Filter7. Climate Control Air Filter Cover8. Cluster Ionizer9. Blower Upper Case10. Blower Lower Case11. Power Mosfet12.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Motor Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, replace it with a genuine blower motor check for proper operation. 3. Replace the blower motor if it is proved that there is a problem with it.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0205