Hyundai Genesis (DH): Airbag Module / Driver Airbag (DAB) Module and Clock Spring Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring Description and Operation
| Description |
The Driver Airbag (DAB) is installed in the steering wheel
and electrically connected to SRSCM via the clock spring. It protects
the driver by deploying the airbag when frontal crash occurs. The SRSCM
determines deployment of the Driver Airbag (DAB).
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the
circuit resistance is measured with a tester, accidental airbag
deployment will result in serious personal injury. |
Components 1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures
R
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Transmission Control Module (TCM) Repair procedures
- Description and Operation
- Restraint
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0214