Hyundai Genesis (DH): Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to

    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. The two Knock Sensors (KS) are installed inside the V-valley of the cylinder block and sense engine knocking.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description Control Function This system supports 2 kinds of main function. (Rear video display function, Expected trace of wheels display function) The Rear video display and the expected trace of wheels display operate according to Vehicle speed condition and Gear position.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0346