Other information:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the ECTS connector.
3.
Remove the ECTS (Refer to "Removal").
4.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.
5.
Check that the resistance is withi ...
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Put a flat tool(O4mm) into a guide hole located in the bottom of steering wheel and press a spring.
When put a tool into a hole, make sure not to damage an ...