| Specifications |
| Pressure [kPa (kgf/cm?, in H2O) | Output Voltage (V) |
| '-6.67 (-0.068, -26.8) | 0.5 |
| 0 | 2.5 |
| '+6.67 (0.068, 26.8) | 4.5 |

Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister.
Circuit Diagram
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.