| Specification |
| Item | Specification |
| Coil Resistance (?) | 1.04 ~ 1.27 [23 |
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls the fuel amount flowing into the injectors in accordance with the ECM signal calculated based on various engine condition.
Signal Waveform Idle rail pressure regulator waveform
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Component Location Components 1. Seal2. Intake Duct Case3. Intake Door4. Intake Actuator5. Intake Duct Case (A)6. Climate Control Air Filter7. Climate Control Air Filter Cover8. Cluster Ionizer9. Blower Upper Case10. Blower Lower Case11. Power Mosfet12.