Hyundai Genesis: Front Suspension System / Front Upper Arm Repair procedures

Removal

1.	Remove the front wheel and tire (A) from the front hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) • Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

2.	Remove the front strut assembly. (Refer to Front Suspension System - "Front Strut Assembly")

3.	Disconnect the front upper arm (A) from the front strut assembly bracket (B) by loosening the bolt. Tightening torque: 98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.	Installation is in the reverse order of removal. • Keep mind in upper arm installing angle.

5.	Check the alignment. (Refer to Tires/Wheels - "Alignment")

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check the ball joint for rotating torque.

Front Strut Assembly Repair procedures

Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub. Tightening torque: 88.3 ~ 1 ...

Front Lower Arm Repair procedures

Replacement [4WD] Remove the lateral arm 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Front Seat Back Cover Repair procedures

Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a p ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Oil Pan Repair procedures

Removal [Lower oil pan] 1. Disconnect the battery "-" terminal from the trunk room. 2. Remove the engine under cover. (Refer to Engine And Transaxle Assembly - "Engine Room Under Cover") 3. Drain the engine oil. (Refer to Lubrication System - "Engine Oil") 4. Remove the lower ...