Hyundai Genesis (DH): Windshield Wiper/Washer / Head Lamp Washer Motor Repair procedures

Removal
Head Lamp Washer Motor
   
-
When servicing the washer pump, be careful not to damage the washer pump seal.
-
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the right wheel house cover.
3.
Remove the hose (A) for washer reservoir inlet.

4.
Disconnect the connector (A).

5.
Remove the reservoir washer inlet (A) after loosening the mounting bolt.

6.
loosening the mounting bolt (A).

7.
Remove the washer reservoir.
8.
Remove the head lamp washer hose (A)

9.
Remove the connector mounting bracket (A) after loosening the screws.

10.
Remove the head lamp washer motor (A) after disconnect the head lamp washer motor connector (A).

Head Lamp Washer Actuator
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Remove the head lamp washer actuator (A) after loosening the mounting bolts and remove the hose (B).

Installation
Head Lamp Washer Motor
1.
Reassemble the washer reservoir.
   
Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.
2.
Install the washer reservoir.
3.
Connect the washer motor connector and washer hose.
4.
Reassemble the right wheel house cover.
Head Lamp Washer Actuator
1.
Install the head lamp actuator and hose.
2.
Install the front bumper cover.
3.
Connet the negative (-) battery terminal.

    Inspection Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.     Before filling the reservoir tank with water, check the filter for foreign material or contamination.

    Components and Components Location 1. Horizontal light sensor2. Vertical light sensor3. Solar load sensor4. Rain sensor - left5. Rain sensor - right

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Description and Operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low-pressure and low-temperature refrigerant gas into high-pressure and high-temperature refrigerant gas.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and control the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. Specification Fan Speed (Manual)Motor Voltage (V)13.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.049