Other information:
Removal
1.
Remove the crankshaft pulley.
(Refer to Timing System - "Crankshaft Pulley")
2.
Remove the timing chain cover oil seal (A).
Installation
1.
Using SST (09231-3C100), install timing chain cover oil seal.
Always use a new oil seal.
2.
Install the c ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification: Refer to “Specification”
Removal
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
2.
Fold the rear seat cushi ...