Other information:
Removal
1.
Disconnect the battery sensor connector (A), battery negative terminal (B) and positive terminal (C).
2.
Disconnect the vent hose connector (A) from the battery air vent hole.
3.
Remove the mounting bracket (A) and then remove the battery (B).
Installation
1.
Install in t ...
Removal
For the vehicle equipped with the immobilizer, the procedures shown below must be performed after replacing the ECM.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group)
2) After finishing ...