Hyundai Genesis: General Information / Basic Service Symbols

Hyundai Genesis (DH) 2013-2016 Service Manual / General Information / Basic Service Symbols

Basic Service Symbols

There are five primary symbols used to complement illustrations. These symbols indicated the materials to be applied to parts during service.

Symbol	Meaning
	Do not reuse the part. Replace a new one.
	Apply engine oil or transmission oil to the part.
	Apply automatic transmission fluid (ATF) to the part.
	Apply grease to the part.
	Apply sealant to the part.

General Tightening Torque Table

Tightening Torque Table of Standard Parts BOLT (Nominal diameter)NUT (Nominal diameter) BOLT/NUT Thin screw Torque Nm (kg.m, Ib-ft) Nominal diameter. (mm)Pitch [mm (in.) ]4T ...

General Service Information

General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas prior to beginning work. The support rod must be inserted into ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor. ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Fuel Sender Assembly Repair procedures

Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line") • When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may turn up. Delete the code with the GDS after completion of � ...