Hyundai Genesis: Warning Messages / Check BSD System. Check PSB
Check BSD System
.jpg)
• This warning message illuminates
if there is a malfunction with the
Blind Spot Detection (BSD) system.
And the BSD system will be
automatically deactivated. In this
case, have your vehicle inspected
by an authorized HYUNDAI dealer.
Check PSB
.jpg)
• This warning message illuminates
if there is a malfunction with the
Pre-safe Seat Belt (PSB) system.
In this case, have your vehicle
inspected by an authorized
HYUNDAI dealer.
Low Tire Pressure
• This warning message illuminates
if the tire pressure is low with the
Engine Start/Stop button in ON
position.
Low Washer Fluid
This warning message illuminates
...
• This warning message illuminates
if there is a malfunction with the
Electronic Control Suspension
(ECS) system. In this case, have
your vehicle inspected by an
authorized HYUNDAI deale ...
Other information:
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the ECM connector (A) and TCM connector (B). IDB (C) and then remove the noise barrier (D).
3.
Remove the Cowl Top Cover.
(Refer to Body - "Cowl Top Cover")
4.
Remove the ECM, TCM & ...
Removal
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from the front hub.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Be careful not to damage the ...