Hyundai Genesis: Interior Trim / Center Pillar Trim Repair procedures
[Center Pillar Lower Trim]
| • |
Put on gloves to prevent hand injuries. |
|
| • |
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
| • |
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. |
| • |
Take care not to bend or scratch the trim and panels. |
|
| 1. |
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim") |
| 2. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim") |
| 3. |
Carefully remove the front door body side weatherstrip. |
| 4. |
Carefully remove the rear door body side weatherstrip. |
| 5. |
Using a screwdriver or remover, remove the center pillar lower trim (A). 
|
| 6. |
Install in the reverse order of removal.
| • |
Make sure the connector is connected properly. |
| • |
Replace any damage clips. |
|
|
[Center Pillar Upper Trim]
| • |
Put on gloves to prevent hand injuries. |
|
| • |
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
| • |
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. |
| • |
Take care not to bend or scratch the trim and panels. |
|
| 1. |
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim") |
| 2. |
Remove the front anchor seat belt (A). 
|
?How to detach the anchor seat belt
1) Expose the red-colored indicator pin (A) by pushing the slot hole with a O 1.5mm pointed tool as the illustration below.
|
Be careful not to scratch the anchor cover with a pointed tool when pushing the slot hole. |
2) Put a (-) driver (O4mm) into a latch hole ( ) and turn it clockwise.
3) Remove the connector by pulling seat belt ( ).
|
When connecting the anchor connector, securely connect it until "click" sound is heard. 
|
|
|
| 3. |
Using a screwdriver or remover, remove the center pillar lower trim (A). 
|
| 4. |
Install in the reverse order of removal.
| • |
Replace any damaged clips. |
|
| • |
When coupling the tongue to the buckle, be careful not to twist the belt. 
|
|
|
Component Location
1. Center pillar lower trim2.Center pillar upper trim
...
Component Location
1. Rear pillar trim
...
Other information:
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance
with the ECM control signal which is calculated by the engine speed and
load.
By controlling CVVT, the valve over-lap or under-lap occurs,
which m ...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between solenoid valve terminals.
4.
Check that the resistance is within the specification. ...
Center Pillar Trim Components and Components Location
Rear Pillar Trim Components and Components Location