Hyundai Genesis: Automatic Transmission Cooling System / ATF Warmer Repair procedures

Removal

1.	Draining the coolant. (Refer to Engine Mechanical System - "Coolant")

2.	Remove the exhaust manifold. (Engine Mechanical System - "Exhaust Manifold")

3.	Remove the oil cooler tube (A). • Replace the O-ring (A) before reinstalling the oil cooler tube. • After the installation, start the engine and then check if there are any leakages from the hose.

4.	Disconnect the clamp and then cooling hose (A).

5.	Remove the ATF Warmer (C). • Carefully install the clamp not to damage the hose. • Install the clamp in a correct direction not to interfere with other parts. • After the installation, start the engine and then check if there are any leakages from the hose.

Installation

1.	To install, reverse the removal procedure. • After checking the oil level, refill the automatic transmission with fluid. (Refer to Hydraulic System - "Fluid") • Refill coolant. (Refer to Engine Mechanical System - "Coolant")

ATF Warmer Components and Components Location

Component Location 1. ATF Warmer2. Transmission3. Transfer case(AWD) ...

Hydraulic System

...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures

Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the forward facing sensor. 3. Head a light to the rearward-facing sensor. 4. The ECM shall dim as soon as the rearward-facing sensor detect ...

Hyundai Genesis (DH) 2013-2016 Owners Manual: Checking the engine coolant level

WARNING Never remove the radiator cap or the drain plug while the engine and radiator are hot. Hot coolant and steam may blow out under pressure, causing serious injury. Turn the engine off and wait until the engine cools down. Use extreme care when removing the radiator ca ...