Hyundai Genesis (DH): Electro Chromic Inside Rear View Mirror / Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Electro Chromic Inside Rear View Mirror / Repair procedures

Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the forward facing sensor.
3.
Head a light to the rearward-facing sensor.
4.
The ECM shall dim as soon as the rearward-facing sensor detects a certain level of brightness.
   
If this test is performed in daytime, the ECM may be darkened as soon as the forward facing sensor is covered.
5.
In the reverse gear, the ECM shall not dim.
When directing light to both the forward-facing and rearward-facing sensors, the ECM shall not dim.
Removal
1.
Remove the mirror wiring cover (A) and rain sensor cover (B).

2.
Remove the mirror connector (A).

3.
Remove the mirror (A) by pulling up the mirror in the arrow direction below.
   
Make sure not to damage the mounting bracket when removing the mirror.

Installation
1.
When installing the mirror, be careful not to damage the mounting bracket.
2.
Install the mirror wiring cover and rain sensor cover after reconnecting the connector and tightening the screw.

    Description The ECM (Electro Chromatic inside rear view Mirror) automatically dims when it senses light reflecting in the rear view mirror. The forward facing sensor detects brightness of the surroundings, while the rearward looking sensor is for the light from the rear.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures

    Diagnosis With GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Genesis (DH) 2013-2016 Service Manual: A/C Pressure Transducer Description and Operation

    Description The A/C Pressure Transducer (APT) converts the pressure value of high-pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it at high speed or low speed.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0232