Hyundai Genesis: Automatic Transmission System (SBC) / Automatic Transmission Cooling System

Automatic Transmission Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the under cover. (Refer to Engine Mechanical System - "Engine room under cover") 3. Remove th ...

ATF Warmer Description and Operation
Description The ATF warmer is mounted on the transmission to reduce oil viscosity frictionby increasing the temperature of oil in cold state, which in turn improves fuel efficiency It is mounte ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Pillar Trim Repair procedures


Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a p ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures


Adjustment Introduction It is necessary to check and input the calibration data when the controller is replaced as the characteristics of the internal frictional materials (clutch pack) change due to driving. Creation condition and calibration method 1. In case of replacing the transfe ...

© 2013-2023 www.hgenesisdh.com