Hyundai Genesis: Maintenance / Air cleaner

Filter replacement

The air cleaner filter can be cleaned for inspection using compressed air. Do not attempt to wash or to rinse it, as water will damage the filter. If soiled, the air cleaner filter must be replaced.

We recommend that you visit an authorized HYUNDAI dealer to replace air cleaner filter. Replace the filter according to the Maintenance Schedule

✽ NOTICE

If the vehicle is operated in extremely dusty or sandy areas, replace the element more often than the usual recommended intervals (refer to “Maintenance Under Severe Usage Conditions” in this chapter).

CAUTION

• Do not drive with the air cleaner filter removed. This will result in excessive engine wear.
• When removing the air cleaner filter, be careful that dust or dirt does not enter the air intake, or damage may result.
• Use HYUNDAI genuine parts, use of non-genuine parts could damage the air flow sensor.

Parking brake

Checking the parking brake Foot type Check whether the stroke is within specification when the parking brake pedal is depressed with 44 lb (20 kg, 196 N) of force. Also, the parking brake ...

Climate control air filter

Filter inspection The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads f ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Variable Intake Solenoid (VIS) Valve Description and Operation

Description Variable Intake manifold Solenoid (VIS) valves are installed on the intake manifold (VIS Valve 1) and the surge tank (VIS Valve 2). These VIS valve 1 and 2 control vacuum modulators which activate valves in the intake manifold and the surge tank. These valves opens or closes b ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rail Pressure Sensor (RPS) Description and Operation

Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control co ...