| Troubleshooting |
| Symptoms | Possible Causes | Remedy |
| Warning illuminated "Check active air flap system" | Active Air Flap System Fail (Flap stuck) |
Removal and Installation 1. Disconnect the battery "-" terminal from the trunk room. 2. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 3.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (B) from the parking assist sensor (A).
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position when connected in reverse.