Hyundai Genesis (DH): Automatic Transmission Control System / 8LR Brake Control Solenoid Valve Specifications

Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 8LR Brake Control Solenoid Valve Specifications

Specifications
Direct control VFS[8LR/B]
? Control Type : Normal low type
Control Pressure kpa (kgf/cm?, psi)
0~2108.42
(0~21.5~305.80)
Current value(mA)
0~1100
 Internal resistance(?)
5.0~5.6

    Description 8LR Brake control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 8LR Brake.

    Circuit Diagram

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.

    Categories

     
    Copyright В© 2025 www.hgenesisdh.com - 0.0263