Hyundai Genesis: Automatic Transmission Control System / 8LR Brake Control Solenoid Valve Description and Operation

Description
8LR Brake control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 8LR Brake.

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between solenoid valve terminals. 4. Check that the resistance is within the spec ...

8LR Brake Control Solenoid Valve Specifications
Specifications Direct control VFS[8LR/B] ? Control Type : Normal low type Control Pressure kpa (kgf/cm?, psi)0~2108.42 (0~21.5~305.80)Current value(mA)0~1100 Internal resistanc ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Front Driveshaft Repair procedures


Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub.     Be careful not to damage the hub bolts when removing the front wheel and tire. 3. Remove the brake cal ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Front Door Latch Repair procedures


Replacement 1. Remove the front door module. (Refer to Front Door - "Front Door Module") 2. To remove the front door outside handle base connector (A), widen both sides of the wiring fastener (A) and then push back the front door outside handle base connector. 3. Loosen the front d ...

© 2013-2023 www.hgenesisdh.com