If the vehicle needs to be towed, call a professional towing 
service. It is very dangerous to tow a vehicle with just a rope or 
chain. 
There are three popular methods of towing a vehicle : 
| -  | 
 Flat-bed Towing 
The operator loads the vehicle on the back of truck. This is the best way to transport the vehicle.   | 
| -  | 
 Wheel Lift Towing 
The tow truck uses two pivoting arms that go under the tires 
of the driving axle and lift them off the ground. The other two wheels 
remain on the ground.  | 
| -  | 
 Towing with slings 
The tow truck uses metal cables with hooks on the ends. These
 hooks go around parts of the frame or suspension, and the cables lift 
that end of the vehicle off the ground. The vehicle's suspension and 
body can be seriously damaged if this method of towing is attempted. 
If the vehicle cannot be transported by the flat-bed towing, 
it should be towed with the wheels of the driving axle off the ground.  | 
Manual Transaxle 
|  •  | 
 Release the parking brake.   | 
|  •  | 
 Shift the Transaxle to neutral   | 
Automatic Transaxle 
|  •  | 
 Release the parking brake.   | 
|  •  | 
 Shift to [D] position, then [N] position.   | 
|  •  | 
 Turn off the engine.  
|  •  | 
 The vehicle equipped with full-time 4WD should be only transported on a flat-bed.   |   
|  •  | 
 Improper towing preparation will damage the transaxle. Follow
 the procedure above exactly. If you cannot shift the transaxle or start
 the engine(automatic transaxle), your vehicle must be transported on a 
flatbed.   |   
|  •  | 
 It is the best to tow vehicle no farther than 30km (19miles),
 and keep the speed below 50km/h (30mph). (For the full-time 4WD 
vehicle, limit the towing distance to 1.5km (1mile) and 15km/h (10mph)   |   
|  •  | 
 Trying to lift or tow your vehicle by the bumpers will cause 
serious damage to the vehicle. The bumpers are not designed to support 
the vehicle's weight.  |   
 |   
 | 
Front :

Rear :

Towing when ECS malfunctions
If the ECS malfunction indicator illuminates when there is no
 air in the suspension, the vehicle height will become low, so do not 
drive to protect the vehicle from the projections on the surface of the 
ground. The vehicle should be only transported on a flat-bed.
Take your vehicle to an authorized HYUNDAI dealer by towing the vehicle and have the system checked. 
| 
 When you load the vehicle onto the tow truck, the loading angle should be smaller than 6°. 
If a disabled vehicle is immobile, do not forcibly continue the towing.  | 
 
   Lift And Support Points
    
When heavy rear components such as suspension, fuel tank, 
spare tire, tailgate and trunk lid are to be removed, place additional 
weight in the lugg ...
   
 
   Other information:
   Removal
1.
Disconnect the negative (-) battery terminal.
2.
Open the trunk, remove the left trunk trim.
(Refer to Body - "Trunk Trim")
3.
Remove the external amplifier (C) after disconnecting the connector (A),(B) and loosening the mounting nuts.
Installation
1.
Install the externa ...
   
   Specifications
TerminalResistance (k?)2 - 42.76 ~ 4.132 - 31.89 ~ 2.843 - 41.71 ~ 2.84
 ...