Hyundai Genesis: Tires/Wheels / Tire Repair procedures

• Tires and wheel other than those of the recommended sizes may cause unusual handling and poor vehicle control, resulting in a serious accident.

Tire Wear

1.	Measure the tread depth of the tires. Tread depth [limit] : 1.6 mm (0.0630 in.)

2.	If the remaining tread depth (A) is less than the limit, replace the tire. When the tread depth of the tires is less than 1.6 mm(0.063 in), the wear indicators (B) will appear.

Removal

1.	Remove valve core and deflate the tire.

2.

Remove the bead area in the side of the tire from the wheel using the tire changing machine. • The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too deep. • Avoid tire/tool contact with the valve on dismount. • Dismount should end near the valve.

3.	Rotate the wheel clockwise.

Installation

1.	Apply tire soap or lubrication to the top and bottom tire beads.

2.	To fit the bottom bead, position the valve at the 5 o’clock position relative to the head on the tire changing machine.

3.	Place the tire on the rim so the bottom bead touches the edge of the rim after the valve (6 o’clock). Rotate the rim clockwise, and push down on the tire at the 3 o’clock position to fit bottom bead.

4.	After bottom bead is on tire, rotate the rim until the valve is at the 5 o’clock position relative to the head on the tire changing machine. Push down on the tire at the 3 o’clock position and rotate the rim clockwise to fit the top bead.

5.	Inflate the tire until both beads are completely seated. Tire pressure : 18(inch) : 230kPa (33psi) 19(inch) Front : 230kPa (33psi) 19(inch) Rear : 240kPa (35psi)

Tires/Wheels

...

Wheel Repair procedures

Wheel Runout 1. Jack up the vehicle and support it with jack stands. 2. Measure the wheel runout with a dial indicator as illustrated. 3. Replace the wheel if the wheel runout exceeds the ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Steering Column and Shaft Repair procedures

Replacement 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the front wheels are placed in the straight ahead position. 3. Remove the airbag module. (Refer to Restraint - "Driver Airbag (DAB) Module and ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures

Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, and put a finger on the open end of the PCV valve to make sure that the intake manifold vacuum turns to vacuum state. ...