Hyundai Genesis (DH): Cooling System / Thermostat Components and Components Location
| Components |
| 1. Water temperature control Assembly 2. Thermostat | 3. Coolant inlet fitting |
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage
Removal and Installation Removal of the thermostat will have an adverse effect, leading to lowered cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Cluster Ionizer Repair procedures
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Steering System
- Starter Repair procedures
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- New on site
- Most important about car
