Hyundai Genesis: Heater / Temperature Control Actuator Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Temperature Control Actuator Description and Operation

Description

The temperature control actuator is located in the heater unit. It regulates the temperature according to the procedures as follows.

The temperature control actuator is operated by the temperature switch and adjusts the position of the temperature door to regulate discharge temperature.

Heater Unit Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. When the engine cools down, drain the engine coolant ...

Temperature Control Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Upper Arm Repair procedures

Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the rear hub. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) Be careful not to damage the ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Injector Drive Box (IDB) Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the ECM & TCM & IDB bracket. (Refer to Engine Control System - "ECM") 3. Disconnect the TCM (B) from the bracket after loosening mounting bolt (A). 4. Disconnect the IDB (B) fro ...