Hyundai Genesis (DH): Brake System / Stop Lamp Switch Description and Operation
| Description |
| The stop lamp switch plays the role of supplying signals to
turn on stop lamps and convenience devices (HECU, ECU, BCM, SML, etc.).
The stop lamp switch is a system for drivers to express their intention
to the brake by press the brake pedal. |
Components Location 1. Brake pedal member assembly2. Stop lamp switch3. Clevis pin4. Snap pin5. Brake pedal stopper6. Return spring7. Bolt
Schematic Diagram System Circuit Diagram Terminal function Description1IGN12Engine Control Module (ECM)3B+4Stop Lmap
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Combination Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. After loosening the nuts (4EA) holding the rear combination lamp and disconnecting the connector (A), remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turning it in the counter clock-wise direction.
Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Parking Assist Sensor Repair procedures
- 4 Wheel Drive (AWD) System
- Body (Interior and Exterior)
- New on site
- Most important about car
