| Description |
Never attempt to measure the circuit resistance of the Seat
Belt Pretensioner (BPT) even if you are using a specified tester. If the
circuit resistance is measured with a tester, the pretensioner will be
ignited accidentally. This will result in serious personal injury. |
Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.