Hyundai Genesis: Interior Trim / Rear Wheel House Trim Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. • Take care not to bend or scratch the trim and panels.

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Remove the rear seat back assembly. (Refer to Rear Seat - "Rear Seat Assembly")

3.	Carefully remove the rear door body side weatherstrip.

4.	Remove the rear door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

5.	Remove the rear pillar trim. (Refer to Interior Trim - "Rear Pillar Trim")

6.	After loosening the mounting bolts, remove the rear wheel house trim (A).

7.	Install in the reverse order of removal. • Replace any damage clips.

Rear Wheel House Trim Components and Components Location

Component Location 1. Rear wheel house trim ...

Rear Package Tray Trim Components and Components Location

Component Location 1. Rear package tray trim ...

Other information:

Hyundai Genesis (DH) 2013-2016 Owners Manual: Electric power steering (EPS)

The system assists you with steering the vehicle. If the engine is turned off or if the power steering system becomes inoperative, you may still steer the vehicle, but it will require increased steering effort. Should you notice any change in the effort required to steer during normal ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Fuel Pressure Sensor (FPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Specification: Refer to “Specification” Removal 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Fold the rear seat cushi ...