Hyundai Genesis: Interior Trim / Rear Package Tray Trim Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. • Take care not to bend or scratch the trim and panels.

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Remove the rear seat back assembly. (Refer to Rear Seat - "Rear Seat Assembly")

3.	Carefully remove the rear door weatherstrip.

4.	Remove the rear door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

5.	Remove the rear pillar trim. (Refer to Interior Trim - "Rear Wheel House Trim")

6.	Remove the rear wheel house trim. (Refer to Interior Trim - "Rear Wheel House Trim")

7.	After loosening the mounting bolt, remove the rear seat belt lower anchor (A). [LH, RH] Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

8.	After loosening the mounting screws, remove the rear package tray trim (A).

9.	Install in the reverse order of removal. • Make sure the connector is connected properly. • Replace any damage clips.

Rear Package Tray Trim Components and Components Location

Component Location 1. Rear package tray trim ...

Trunk Trim

...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: General Information

General 1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is no elongation, twisting or bending. 3. For measuring dimensions, both projected dimension and actual-measurement dimension are used in thi ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

Description The smart cruise control system allows a driver to program the vehicle to control the speed and following distance by detecting the vehicle ahead without depressing the brake pedal and the accelerator pedal. 1. Cruise speed control: The vehicle maintains the selected speed if ...